| Key Data Set Information | |
| Location | DE |
| Geographical representativeness description | Europe |
| Reference year | 2024 |
| Name |
|
| Technical purpose of product or process | VENTILATION OF BUILDINGS, OFFICES AND PRODUCTION FACILITIES. For more information see: https://www.trox-xfans.de/en/roof-ventilation-fans/drv-ec-d69e36dccc9c5635 Flow rate max. 60°C. Vertical blowing. Direct drive by alternating current. Operating input voltage 1~200-277 VAC/ 50-60Hz or 3~400V AC/ 50-60Hz. Motor in EC external rotor design, up to 90% motor efficiency, protection class IP 54. Motor protection devices: Fault signalling relay with potential-free contact, blocking protection, phase failure detection, soft start, mains undervoltage detection, overtemperature protection of the electronics and motor, short-circuit protection, Additional motor protection switching devices are not required. Infinitely variable control via 0-10V signal. Contact protection grille. Motor arranged within the air flow. Wiring on site through the housing into the motor compartment, not required when using the repair switch. Optionally with constant volume flow or pressure control. In accordance with ErP 1253/2014: minimum efficiency level 2 (from 2018) is fulfilled This EPD includes the environmental data of the product series DRV-EC. The following represents a representative dataset of the most sold variant in the declared sales year (DRV-ECF355). |
| Classification |
Class name
:
Hierarchy level
|
| General comment on data set | Data quality: Specific data for the product composition are provided by the manufacturer. The data represent the production of the declared product and were collected for EPD development in the year of study. Background data is based on EPDs according to EN 15804 and different LCA databases. The data quality of the raw materials in A1 is presented in the table below. Allocation: The allocation is made in accordance with the provisions of EN 15804. Energy, water and waste production in-house is allocated equally among all products through mass allocation. Effects of primary production of recycled materials is allocated to the main product in which the material was used. The recycling process and transportation of the material is allocated to this analysis. Cut-off criteria: All major raw materials and all the essential energy is included. The production processes for raw materials and energy flows with very small amounts (less than 1%) are not included. These cut-off criteria do not apply for hazardous materials and substances. |
| Copyright | Yes |
| Owner of data set | |
| Quantitative reference | |
| Reference flow(s) |
|
| Biogenic carbon content |
|
| Time representativeness | |
| Data set valid until | 2029 |
| Time representativeness description | "2024-01-19" - "2029-01-19" |
| Technological representativeness | |
| Technology description including background system | Nominal sizes 180 - 500. Volume flows up to 17,750 m³/h. Pressure difference up to 625 Pa. For more information see: https://www.trox-xfans.de/en/roof-ventilation-fans/drv-ec-d69e36dccc9c5635 |
| Subtype | specific dataset | ||||
| LCA methodology report | |||||
| Data sources, treatment and representativeness | |||||
| Documentation of data quality management | |||||
| Data source(s) used for this data set | |||||
| Completeness | |||||
| Validation | |||||
| |||||
| Compliance Declarations | |||||
| Compliance |
Compliance system name
EN 15804+A2
|
Approval of overall compliance
Fully compliant |
Nomenclature compliance
Fully compliant |
Methodological compliance
Fully compliant |
Review compliance
Fully compliant |
Documentation compliance
Fully compliant |
Quality compliance
Fully compliant |
| Compliance |
Compliance system name
|
Approval of overall compliance
Fully compliant |
Nomenclature compliance
Fully compliant |
Methodological compliance
Fully compliant |
Review compliance
Fully compliant |
Documentation compliance
Fully compliant |
Quality compliance
Fully compliant |
| Compliance |
Compliance system name
|
Approval of overall compliance
Fully compliant |
Nomenclature compliance
Fully compliant |
Methodological compliance
Fully compliant |
Review compliance
Fully compliant |
Documentation compliance
Fully compliant |
Quality compliance
Fully compliant |
| Data generator | |
| Data set generator / modeller |
|
| Data entry by | |
| Time stamp (last saved) | 2024-09-19T20:22:53 |
| Data set format(s) | |
| Publication and ownership | |
| UUID | c6f4ff42-b305-4b02-b485-75209dc6a95f |
| Date of last revision | 2024-01-17T10:31:31.8950669Z |
| Data set version | 00.03.000 |
| Registration authority | |
| Registration number | NEPD-5850-5126 |
| Owner of data set | |
| Copyright | Yes |
| License type | Free of charge for all users and uses |
| Access and use restrictions | None |
Indicators of life cycle